Go to Advanced -> USB Configuration and set Third Party USB 3.2 Controller to. Press to save the settings and exit setup. Adjust the M.2 slots - RST PCie Storage Remapping that you've installed PCIE SSDs to. Go to Boot -> CSM and set Launch Storage OpROM policy to. Go to Advanced -> Storage Configuration and set SATA Mode Selection to. Enter the UEFI Setup Utility by pressing or hotkey during the post screen. Please make sure to use identical PCIE SSDs that are the same type and volume.įollow the steps below to adjust the BIOS settings to configure the PCIe RAID. Information such as TPM version can be found in the TPM Management window. Step 3 – The TPM Management window will open.
Ene cir receiver io conflict windows#
Step 2 – Type in "TPM.MSC" to open the Windows TPM management tool. Step 1 – Press hotkeys "Windows + R” together to open the Run box. To check the TPM version, please refer to the following steps. Step 3 – Click the "Resume protection” as shown in the red-boxed below.įor more information, please refer to the Microsoft website. Step 2 – Click the "Suspend protection” as shown in the red-boxed below. The bitlocker feature can be suspended and resumed when Bitlocker Drive Encryption is enabled. Step 2 – The Bitlocker status is shown under the red-boxed section as in the following picture. Step 1 – Please go to Control Panel > System and Security > Bitlocker Drive Encryption To check the Bitlocker status, please refer to the following steps. Please refer to the following for the Bitlocker status, Suspend / Resume Bitlocker and TPM version information. (a) Go to "Advanced" \ "CPU Configuration" page to find. The actual support may be varied based on official release of Windows 11 by Microsoft®. (b) Enabled "Intel® Platform Trust Technology” under UEFI BIOSįor the new Microsoft® Windows 11 installation, we recommend disabling the CSM setting before using the AMD CPU fTPM. (a) Go to "Security page” to find the "Intel® Platform Trust Technology” option. It supports the TPM2.0 feature without TPM2.0 hardware module.įor the new Microsoft® Windows 11 installation, we recommend disabling the CSM setting before using the Intel® PTT. No, please enabled or feature under UEFI BIOS.
0 kommentar(er)
